[EA-7 Edgley Optica constant roll left and slow elevator trim]

1 hour ago, John Dow said:

Confirm that your flight model is Modern not Legacy.

 

I have no tendency to roll in flight.

 

Some find the elevator control too sluggish, the quick fix is to change the sensitivities in your Controls in MSFS, and save as an Optica profile.  DOn't just save generally or your Asobo aircraft will be far too skittish.  I used 25% for roll and 50% for pitch when I set my profile, however I now use FSUIPC.

 

If you have FSUIPC you can tailor the sensitivities and save for each aircraft, the thing to remember is you need to disable the MSFS control that you are setting up in FSUIPC.  So far I have only set the three primary control axes as the rest all seem to work well enough in MSFS.

Thanks for the reply and the suggestions.

 

The Modern flight model was set.

 

I changed the sensitivities as suggested.

 

I do not use the FSUIPC for control management.

 

This did not fix the issues.

 

I have also replaced TCA throttle with alpha yoke, to test, unfortunately no change.

It seems as there is a roll force applied to the plane, rather strange.

 

[EA-7 Edgley Optica constant roll left and slow elevator trim]

Optica seems to be rolling left when airborne.

 

Additionally, the elevator trim is sluggish, takes a lot on bravo throttle to effect the trim.

 

I am using TCA joystick, bravo throttle and Logitech rudder pedals.

 

I tried to play with sensitivities but alas no fix.

 

Unable to determine the cause, is it hardware or software (model).

 

ref: Flight Simulation forum