Festijn Posted July 20, 2014 Share Posted July 20, 2014 Hi, I had Global + Vector installed. And default EBBR + airport elevation automatically corrected by latest version of vector. Everything was fine. Today I installed Open LC europe. When i launched my flight at EBBR I was surprised to see that 2 of the 3 runways are covered by elevations. What could be the problem? What could I do to correct this? Thanks for your help. Regards Festijn Link to comment Share on other sites More sharing options...
Festijn Posted July 21, 2014 Author Share Posted July 21, 2014 I included a new picture. It's only about the runways indicated by the two arrows. (the content in the third arrow in previous picture is correct) Any ideas what i could do or try to resolve this problem? Regards Festijn Link to comment Share on other sites More sharing options...
Festijn Posted July 21, 2014 Author Share Posted July 21, 2014 Hi, this topic can be closed. I used the emt tool for the installation of my fsgenesis mesh. When I install ORBX stuff I always disable the tool before. But when I use P3D I leave emt-tool enabled. Now I tried to use P3D with emt-tool disabled and everything is correct! So the problem is with the emt-tool and not open LC europe !!! Ps. Will my fsgenesis mesh be disabled in this off mode? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.