jerdoo Posted January 17, 2012 Share Posted January 17, 2012 Hi, i was wondering around at YWOL and noticed that there is no people flow at this airport. Looks like a little software glitch in the matrix? Regards, Link to comment Share on other sites More sharing options...
Misha Cajic Posted January 17, 2012 Share Posted January 17, 2012 Hey Jeroen I know this probably won't help, but worth a shot. Did you install the latest Orbxlibs after installing installing YWOL? If you didn't, do that first before anything else. If you did, give reinstalling the scenery a try. That usually solves any problems I have. Or maybe you accidently disabled it in the control panel? Just some nooby suggestions, i'll leave any troubleshooting to the pros regards, Misha Link to comment Share on other sites More sharing options...
Robair Posted January 17, 2012 Share Posted January 17, 2012 Hi Jeroen, I had the same problem at Jandakot a while back. Check that you have the scenery set at least to dense, this might bring people flow back, not sure but it did for me. Rob Link to comment Share on other sites More sharing options...
jerdoo Posted January 17, 2012 Author Share Posted January 17, 2012 Thanks for that Misha ... i didn't install the libraries as the installer of the scenery has the latest as far as i can recall ... i didn't disable it in the control panel but to be sure i'll check both again ... again thanks for the reply and i'll get back to this when i'm done checking Link to comment Share on other sites More sharing options...
jerdoo Posted January 17, 2012 Author Share Posted January 17, 2012 Thanks a lot Rob ... I installed the latest libraries and it seems to have done the trick for me ... so the people flow is back Link to comment Share on other sites More sharing options...
Ed Correia Posted January 17, 2012 Share Posted January 17, 2012 Glad to see this has been sorted Jeroen. Thank you Misha & Rob for the suggestions. Link to comment Share on other sites More sharing options...
Misha Cajic Posted January 18, 2012 Share Posted January 18, 2012 Thanks a lot Rob ... I installed the latest libraries and it seems to have done the trick for me ... so the people flow is back No problems Jeroen, enjoy the scenery Link to comment Share on other sites More sharing options...
Recommended Posts