Jump to content

Flying under Sydney Harbour Bridge in Cityscape Sydney


Recommended Posts

Hi all, I have just purchased and downloaded Cityscape Sydney.  Installation all went fine and I've been flying around checking out the site.  However when I try to fly under the Sydney Harbour Bridge I get the error that I have not put my landing gear down and the sim wants to restart.  So I can only assume that I have hit the ground while trying to fly under the bridge.  I have tried this a few times and I am sure I am not hitting either the ground or the bridge itself.  So the question is, is it possible to fly under the bridge or is the map not set up to allow this?  Oh and I will add that I also tried this on the Anzac Bridge with the same results.  Thanks,

Link to comment
Share on other sites

In order to fly under bridges you need to have your Crash Detection setting disabled.

Do this by choosing Options/General/Developer. When you have developer mode enabled you will get a series of titles on the left side of the upper Task Bar,

Open Options as in the attached: View in full screen for clarity

Capture.thumb.JPG.ba091bee52793dfae26e3b6fb826c753.JPG

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...