rlaycock Posted June 13, 2020 Share Posted June 13, 2020 Hi I started Orbx central today and there was a bunch of updates to install. I went ahead and installed the updates then tried to run Vector AEC. it reports Airport Elevation Correction has failed to complete. I have tried to verify files. reboot.etc but it still will not complete. Also when i try to load a flight on P3d V4.5 I get Path not Found. E:/Prepar 3Dv4\E:\Orbx_Library\P3dv4\AU AustraliaV2\Orbx\FTX_AU\FTXAUv2_05_SCENERY\scenery\*objectflow.xml. If I recall correctly, Australia and Library's and objectflow all required updating but Vector did not. Thanks in advance if you can help. Best wishes Bob Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted June 13, 2020 Share Posted June 13, 2020 Hi Bob If you have NZWR airport installed, please uninstall it and try running the tool again. Also Link to comment Share on other sites More sharing options...
rlaycock Posted June 13, 2020 Author Share Posted June 13, 2020 Hi Doug Thanks for the help I removed NZWR and vector worked I have reinstalled NZWR is this OK? I also followed the other instruction and now P3DV4.5 starts without the error. Is it OK to reinstall NZWR? Being a KIWI I use this airport most of the time. Link to comment Share on other sites More sharing options...
Doug Sawatzky Posted June 13, 2020 Share Posted June 13, 2020 1 minute ago, rlaycock said: Is it OK to reinstall NZWR? Yes. Link to comment Share on other sites More sharing options...
rlaycock Posted June 13, 2020 Author Share Posted June 13, 2020 Cool Thanks for your help Best wishes Bob Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.