Jump to content

answered Auto-configuration has failed to complete error


Recommended Posts

Hi all:

I have been re-installing all of my Orbx products on a fresh install of P3Dv4.6 As I got 8-10 done, I would occasionally run Vector just to make sure I didnt get this error and it was competing just fine. After the LC, Regions, and cities, I finally started installing the individual airports. After they finished I ran Vector Auto-config and this error popped up again that I had seen in the past. Any idea what is causing it?

FTX error.JPG

Edited by vegasjon777
I think this was posted to the wrong forum- sorry about that.
Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...