active Charleston Cityscape Does Not Load

[JMBIII]

Newly installed Charleston Cityscape will not load into sim (P3Dv3.5).

Loading stops at 6% Terrain Data when attempting to start scenario at KCHS. Just stops, No error messages.

If I start some distance away - KECG - simulator loads properly. If I then select 'go to airport' - KCHS, the progress bar stops at 36% Terrain Data.

 

I have ensured there is no other Charleston/KCHS scenery active or installed.

I have deactivated Charleston in the P3D scenery and after selecting KCHS the sim will load normally at the base KCHS scenery.

I have verified the files in/with ORBX Central (v4.0.27) and receive the green check mark.

I have removed and reloaded Charleston with the same results.

I have uninstalled and erased the complete Charleston folder and re-downloaded and installed the  product once more - with the same above results.

 

Win10, P3Dv3.5, on separate SSDs. Intel i5, 16.0G RAM, NVIDIA GeForce GTX 1050 Ti

 

Any recommendations or solutions would be appreciated.

 

Thanks,

Joe

[john548]

Patience is a virtue in this case. It is a well known problem in P3Dv3 that has been solved in P3Dv4 by Lockheed Martin. Some simmers experienced 10 to 20 mins plus for loading times to pass the 6% mark.

Hope this helps.

Cheers.

[JMBIII]

Patience ?  Looks like I won't be flying to Charleston too often.  Finally after 6% for 37 minutes there was KCHS.

Visits will have to wait for P3Dv4 or the new MSFS.