Stefano Biasiotti Posted November 6, 2017 Share Posted November 6, 2017 Hello!, Not always, but sometime I see in some airports (eg ENOV) floating small houses. If I park at the gate, save and reload....sometime I still see them floating...sometime they are where they should...on the ground I have only ORBX products - BASE PACK - OPEN LC NORTH AMERICA - FTX GLOBAL TREES - FTX GLOBAL VECTOR - FTX ICELAND DEMO - EU NORWAY Any idea to have it stable? Thank you, Stefano Link to comment Share on other sites More sharing options...
Lawrence Hickerson Posted November 6, 2017 Share Posted November 6, 2017 Stefano, The only time I have seen floating houses using P3Dv4.1, is when my sliders were above the 3m setting. Has to be something with Vector. Without this setting, I have also seen some lower elevation scenery disappear just below the sea. Hope this helps. Larry Link to comment Share on other sites More sharing options...
Stefano Biasiotti Posted November 6, 2017 Author Share Posted November 6, 2017 2 hours ago, Lawrence Hickerson said: Stefano, The only time I have seen floating houses using P3Dv4.1, is when my sliders were above the 3m setting. Has to be something with Vector. Without this setting, I have also seen some lower elevation scenery disappear just below the sea. Hope this helps. Larry mmh ...thank you...I will check... I have P3D 3.4 so it could be different...and when you say above 3m, which slider are you referring to? Is it related to a too heavy scenario for the Graphic card ? (mine is the NVIDIA 1070 GTX Stefano Link to comment Share on other sites More sharing options...
Nick Cooper Posted November 6, 2017 Share Posted November 6, 2017 Hello, The recommended mesh resolution is 5m. Floating autogen can also sometimes simply be the result of the simulator not drawing autogen correctly, which is why reloading the scenery can remove the error. Link to comment Share on other sites More sharing options...
Stefano Biasiotti Posted November 6, 2017 Author Share Posted November 6, 2017 1 hour ago, Nick Cooper said: Hello, The recommended mesh resolution is 5m. Floating autogen can also sometimes simply be the result of the simulator not drawing autogen correctly, which is why reloading the scenery can remove the error. Thank you Nick My mesh resolution is set to 5. Could the autogen error related to a heavy load of the graphic card (in some moments I read 99% load)? If yes I could try to reduce some sliders to see. Is it right? Stefano PS: by the way....FTX Norway is STUNNING! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.