Jump to content

active KEGE Elevation problem


mark767
 Share

Recommended Posts

I have an elevation problem with KEGE where the land between runways and taxiways is 10ft higher than the rest of the terrain.  I have run the auto elevation tool in Vector and also moved the airpor to the other selection but to no avail.  I have also turned off the BGL from MyTraffic6.  Any ideas, this was working before but i recently updated P3D to 3.4 patch 2.  

Link to comment
Share on other sites

I managed to fix the problem.  My scenery was all out of order, possibly since moving to Central 3.  Re did the order based on some advice I found here and problem resolved.  I just hope Central does not change the order now next time I load it.

Link to comment
Share on other sites

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...