lsummer Posted May 21, 2016 Share Posted May 21, 2016 I loaded in tappini today and when i load the AP in the sim the plane crashes right away, i do have the holgermesh installed. P3d v3.2xx vector and global northern cali southern cali Alaska Link to comment Share on other sites More sharing options...
Nick Cooper Posted May 21, 2016 Share Posted May 21, 2016 Try disabling crash detection and you may be able to see what is causing the problem. Link to comment Share on other sites More sharing options...
lsummer Posted May 21, 2016 Author Share Posted May 21, 2016 ok i tried this and it worked but now i find myself in a hole in the ground when i look up I see the buildings floating in the air Link to comment Share on other sites More sharing options...
lsummer Posted May 21, 2016 Author Share Posted May 21, 2016 http://www.fsfiles.org/flightsimshotsv2/image/G0Ae Link to comment Share on other sites More sharing options...
HighlanderOne Posted May 21, 2016 Share Posted May 21, 2016 I just purchased Tapini and installed now to have a look. Spawned in fine. Elevation is correct. Don't know whats happened on your end but the only advice I can offer is going in to the FTX Vector Config tool... go to Airport Elevations Corrections tab then run Auto Configuration then hit the 'apply' button. Or you could just disable TAP manually under the same tab. Just make sure to apply it. If that doesn't work then I have no idea. I haven't had to disable TAP in FTX Config Tool. Hope that helps. Franky Link to comment Share on other sites More sharing options...
lsummer Posted May 21, 2016 Author Share Posted May 21, 2016 Thanks but I tried that, I tried Turning off vector I tried Turning off holgerhesh. I tried It all no luck . Link to comment Share on other sites More sharing options...
Jorge Bach Posted May 21, 2016 Share Posted May 21, 2016 Try this: Open scenery library, click OK to reload. That correct the flying houses to me. Hope you solve this issue. Kind regards, Jorge. Link to comment Share on other sites More sharing options...
Tim Harris Posted May 22, 2016 Share Posted May 22, 2016 Hi lsummer, Open up FTXcentral >> settings >> troubleshooting >> Start diagnostic reporter, and the paste the code given in here and we'll get you sorted Cheers Tim Link to comment Share on other sites More sharing options...
lsummer Posted May 22, 2016 Author Share Posted May 22, 2016 Thanks Tim here is the code ot625faab13ad67818d2076044108bf7bd Link to comment Share on other sites More sharing options...
Nick Cooper Posted May 22, 2016 Share Posted May 22, 2016 Hello, You appear to have installed the AU Holgermesh. Please visit this page and download PNG Holgermesh. Once you have installed that, I expect your airports will work properly. Link to comment Share on other sites More sharing options...
Tim Harris Posted May 29, 2016 Share Posted May 29, 2016 Just checking you have been able to resolve this Cheers Tim Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.